Catalyst 4006 Trunking Protocol

[jdreed2829]

What is the Command to disable Dynamic Trunking Protocol on a Catalyst 4006 Switch? I thought it was #switchport mode access, But It will not accept the word Switch as part of a command. Any Ideas??

[Jon Marshall · Accepted solution]

James

Are you runnning IOS or CatOS. If IOS then are you using this command in interface configuration mode ie.

4500(config)# int gi4/1

4500(config-if)# switchport mode access

Jon

[jdreed2829]

Jon,

Thanks alot, that was right on the Money. The Tech I was working with did not go into the interface before entering the command.