Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it possible without downtime to change the access vlan on the 2 port-channels used for the ASA cluster control links ? I tried earlier on the switch with int range po 11, po 12 - switchport access vlan [new vlan] and the cluster broked. Maybe ...
Hi, the FTD software (6.2.3.10) on ASA 5506-X does not seem to support point-to-point (/31) ipv4 subnets. When trying to set my static /31 public ip on the outside interface in FDM the error message "You cannot assign a broadcast address as the IP ad...
Hi Marvin,I just reimaged a FPR2110 to ASA 9.20 in appliance mode for RA VPN use and applied your SSL cipher list. A public ecdsa wildcard certificate is enrolled and secure client access is working as expected.However, SSL Labs reports a F grade and...
Update - Firepower 1010 FTD and FDMA year later and still no support for RFC3021 in FTD 7.3.1.1 !!Comparable branch devices from Palo Alto and Fortinet supports this. What's taking so long ?
