Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe are using ACS 5.0 and enabled dot1x , the access switch are configured dot1x port based auth , we are getting error 24427 Access to Active Directory failed ,the isssue could be the ACS is not talking to AD , but the test connection was sucessful...
Hiwe have 2 wic-2T card installed on cisco 2621 router , but we noticed that at a time one WIC-2T card is working we tried all the possible combinationupgraded the IOS image to latest ver in 12.3boot system flash:c2600-i-mz.123-26.binwe swapped the c...
HiAny one help what are the process running Cat4k Mgmt LoPri switch#show processes cpu | exclude 0.00CPU utilization for five seconds: 92%/1%; one minute: 42%; five minutes: 41%PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 2...
HiHope this will help you abt the producthttp://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6021/ps9310/AAG_Cat_4900M.pdfregardskrishna kumar
Hi,After config boot commad for new IOS do write mem and check the next boot loaderusing show boot or show bootvarthis will display the next ios image if it is psssible u can past the outout here we can validate the samethank youregardskrishna kumar
HiThe stacking configuration done automatically when you are connect the stack cable back side of the switchthe connection will be like thisswitch 1 stack port 1 need to connnect switch 2 stack port 2the same vise versa switch 1 stack port 2 need ...
