Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I am using sandbox version of Cisco Modeling Labs. I am writing this to ask in which subnet should i configure my device connected to the external connector. If I use bridged mode, there is no dynamic ip assignment. But if I use NAT mode, then...
What is the equivalent of "next-hop-self all" command in IOS-XE for the IOS XR. This command allows the changing of next hop even when the routes are being learnt from an ibgp neighbor and are shared with another ibgp neighbor. For IOS XR, I am unabl...
Hello all. I am a novice when it comes to segment routing. I have a simple network in which one region has LDP enabled and the other region has SR enabled. I want the SR Enabled routers to have the Node or Prefix-SID for the devices outside of the SR...
Hello. I have a question. Is there a way to configure the image of the devices (such as routers and switches), that whenever I bring them into my lab, they have a start-up config same as the one I configured them with. Like I don't want to configure ...
But in the sample topology which is already present in the CML sandbox, has devices which you can ssh into. So i thought may it is also possible to create a new lab and have an external connector in it and be able to ssh into to the devices in that l...
Dear @Harold Ritter Thanks a lot. I was not using the advertise-local command under the ospf process. It worked. Thank again. Your support means a lot.
I made it one single domain and then issued these commands on R4.segment-routing mpls!connected-prefix-sid-mapaddress-family ipv44.4.4.4/32 absolute 16004 range 1exit-address-family!!mapping-server!prefix-sid-mapaddress-family ipv45.5.5.5/32 absolute...
