About james-mccarthy

james-mccarthy · 08-12-2010

I'm not sure what I'm missing but I can't for the life of me figure out where to set up the SSH and enable credentials in CiscoWorks. I've been searching for a while now and I'm worried that I may be going crazy. I know that under RME there is a sect...

james-mccarthy · 12-03-2009

Hey this may be a ridiculous question but I'm running out of ideas. I need to run a report that will display the Voice VLANS on each switchport. We are doing a major phone/VLAN migration and this report will save a lot of time. The current reports I ...

james-mccarthy · 08-29-2009

Hey everyone, We are currently rebuilding our network and for the time being we want two seperate networks on different VTP domains so that the VLAN's don't mix. Anyways, DTP is turned off (nonegotiate) on all the trunks that are between the VTP doma...

james-mccarthy · 05-09-2008

I'm getting an error with one of the rules that is waiting to be generated. Is there a way to clear the rules waiting to be generated? Error:1: Rules for "computer" have complexity 7947 which exceeds the maximum of 7500

james-mccarthy · 04-08-2008

We recently upgraded to CSA 5.2. For some unknown reason, we don't have anything logged in the event log since 2/13. It was logging fine before then when all the systems were in test mode. I took them out of test mode last week. Neither the database ...

james-mccarthy · 08-12-2010

Thanks! I knew something had changed but I guess it seemed a little odd that they'd merge telnet/ssh into "default credentials". Thanks again!

james-mccarthy · 12-08-2009

Yeah I ran the user tracking report and it did show the secondary VLAN. I was hoping for the VLAN id but I guess I can make that work. Thanks for your help!

james-mccarthy · 08-29-2009

Ok so it started working magically. I don't understand what happened but the problem is solved.

james-mccarthy · 04-14-2008

Yeah I moved them to a different group. Logging was enabled....but I just figured out that there are 900 thousand log entries so it's not logging anything new. I guess I should've checked that first before I posted on here. Thanks for all your help!

james-mccarthy · 12-27-2007

they are splitting the load technically. If I restart either controller all the AP's default to the other one and stay there. But I've been testing the wireless after I disabled MFP and it seems to be working. I tested a laptop on 10 random AP's and ...

Member Since	‎07-31-2007 11:00 AM
Date Last Visited	‎03-03-2021 08:23 AM
Posts	30

User Statistics

User Activity

Credentials in LMS 3.2

VLAN reports in LMS 3.1

No traffic between different VTP domains

How to clear rules

CSA is not logging events

Re: Credentials in LMS 3.2

Re: VLAN reports in LMS 3.1

Re: No traffic between different VTP domains

Re: CSA is not logging events

Re: WLC 4402 slow authentication