Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
greetings, i was wondering if it neccessary to configure the layer 2 security ( port Security, DAI ) once the ISE is deployed and all the access port has been configured for the authentication. what is the recommandations for such senerio.many thank...
Greetings, last week i have face a question and i dind'nt get the write answer for it, it is about the configuration of ASA firewall with FailOver, the question was, when two firewall are connected with fail over, and a originated packet from the ins...
hello all,acually i'am planing to deploy zone based Firewall policy on some Cisco ISR 4300 series Routers,i have monitoring all most the traffic flow get in and out of those router,so i have create two ACLS to match the traffic, one the inside and t...
hi all,i'am stucking in pickle, my replication link gets saturation almost 24H, so for that we are planned to increse the bandwith as showing bellow,my wonderings are :once we have increase our bandwidth, i want to apply the Qos, on that link. dispat...
greetings everyone, nowadays i'am facing a big issue, on my network a have a replication link to our backup datacenter, and this link is a lease link with 20Mbps.latetly some server's jobs fail down since the saturation of this link, and the ping get...
Hello, i know it has been long time, but in case someone face till issue nowadays, you'll find here the solution for the Issue as well an explanation why you have this issue, https://learningnetwork.cisco.com/s/question/0D5QO00001nvVLl0AM/alwayson-vp...
hello, i had the same issue, when the both are configured the ISE users are authentification periodically, and every time they disconnected. till i have disable the port security on the access ports. so it is not support to enable the both on the sam...
