Bonjour,
what are the steps to integrate a real IOS my 2811 router in GNS3 because when I tried it, the GNS3 becomes blocked, and there is no c2800
Thank you in advance for your help.
Hello i do this configuration but i can't insert "dsl operating mode auto" and "pvc 0/38" into the interface giga0/0
when i made my modem in the bridge mode the following configuration does not work, i can't receive the ip adresse from the ISP
ple...
dear mark malone
Hello again,
if I add the ATM WAN modules for 1900, can I use the commands below without adding anther licence of IOS
Commands: "dsl operating mode auto" and "pvc 0/38"
Thank you in advance for your help.
dear mark malone
in the case that the ISP provide just PPPOE, is there solution using an upgrade of IOS or by integrating a new card interface ?
- if the solution is in IOS what is the upgrade that I need it (that support the PPPOE protocol)
- If th...
