Plz Can I have the right syntaxe of how to add a range of IP Address (Exemple:from 192.168.0.2 to 192.168.0.120 /24) when we will add a new network object in FirePower Management center version 6.1
Dear All
i have cisco router 2901 with 4 wic EHWIC-VA-DSL-A and 4 pppoe line from different isp each line 8 MB
so i want aggregation all to have 8 x4 = 32 MB total bandwidth
the problem how config 4 dialer to share traffic to all dialers
and h...
Dear All
i have cisco router 2901 with 4 wic EHWIC-VA-DSL-A and 4 pppoe line from different isp each line 8 MB
so i want aggregation all to have 8 x4 = 32 MB total bandwidth
the problem how config 4 dialer to share traffic to all dialers
and h...
hi Commtechegypt
kindly explain how you make uc 320 work in egypt i have ones but only perform incoming call only not outgoing but this just happen from a few month before that it's work fine , i don't know what happen in isp
any way i want to make...
dear Mr Gajanan
could plz help my i do hard factory default
on phone 7942 then the screen was blank but i see in debug it take only term42.default.loads and then loop
i have cme 4.1
and download firmware cmterm-7942_7962-sccp.8-5-2.zip
please all i have Cisco UCS 6248UP and i want connect fabric to cisco catalyts 3650 g
the switch show error disable becuz gbic not compatible with sfp in 3650 g
is there any other compatible gbic with fabric and switch 3650 ?
thanks