Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,This is my first attempt at migrating from a combination RTR/Switch to two separate units. The router only has two ethernet ports that are already going to be connected to other equipment. The older unit's internal connection wasn't considered ...
Hello,I just installed the ES2-8 module in the 4321 ISR, and the 8 switch ports are showing in the "show run" of the router. This 4321 has a config from the router that is going to be replaced(2911 ISR with switchports). From what I read, it doesnt l...
Hello, In short, I'm working with a closed enclave and have two Linux machines that are connected to a data diode, then to the C1000 switch, which is the NTP master. The NTP works on the other machines that are not attached to the data diode, but are...
I have the SFP's but etherchannel would be overkill for what this system needs. Can I trunk all the vlans on the switch side (SFP) and then set up the router to accept the trunk? I have tried that and cant ping back and fourth. The switch setup seems...
what are the commands to set the policy? The usual command of "aaa common-criteria policy PASSWORD_POLICY" doesnt work on a 9300 switch, running 17.09.04a. There doesn't seem to be a way to set password policies such as length and complexities?
