Hi allSeveral tests are under way using this topology. in case R1 - > R7Only static routing should be used. R1's config track 1 list boolean andobject 2object 3!track 2 ip sla 57 reachability!track 3 ip sla 35 reachability ip sla 35icmp-echo 1.1.35....
HI all.I want to use IP SLA source-interface as Loopback 0 R1's config ip sla 1icmp-echo 2.2.2.2 source-interface loopback 0 !ip sla schedule 1 life forever start now!track 1 ip sla 1 reachability !ip route 2.2.2.2 255.255.255.255 192.168.1.2 trac...
HiI set up BFD and shut down R2 gigabitethernet 0/1.And the routing table of R1.There is still routing to 3.3.3.3.Did I set it up wrong?In this situation, is it impossible to remove the routing of 3.3.3.3 from the routing table of R1?Thank you.
HelloI want to enable communication between loopback 1.1.1.1 of R1 and loopback 3.3.3.3 of R3.R1 route 3.3.3.3 255.255.255.255 192.168.1.2R3 route 1.1.1.1 255.255.255.255 192.168.2.1It seems to fail because the outgoing interface source is 192.168.1....
Of course, return routing exists in R2.But I didn't apply SLA to R2 and I'm testing it.Only static routing is applied.Ping R1 at R2 is normal, but there is no routing of R2 due to SLA operation in R1.Can't source-interface be applied as Loopback 0?Th...
