Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to interpret output from the 'show dot11 statistics client-traffic' command in autonomous IOS version 15.2(4)JB4 on a 3600-series access point. Finding a detailed description of each data point being reported has been very difficult - c'm...
Hello all,I'm fairly new to UCS and would like to know how to balance the placement of servers across multiple B-series chassis using a service profile template. I'm experimenting in the UCS platform emulator and I've built a server pool that includ...
Does anyone know if the Nexus 5000 will support native fiber channel today? It is my understanding that an expansion module is needed but it doesn't look like that expansion module is orderable today. Does anyone have a good, up-to-date reference t...
Do the integrated 10 GigabitEthernet interfaces on the Nexus 5000 and the interfaces on the 32-port 10 GigabitEthernet linecard for the Nexus 7000 support GigabitEthernet connectivity also or just 10Gig? If not, how do I uplink GigabitEthernet ports...
I've seen various configuration & deployment guides that explain the process for configuring guest access using mobility anchors but I'm still confused by one thing...What is the purpose for creating a separate wired guest VLAN on the local switch an...
Thanks for the feedback Brad. I'll try & take a look at the Product Configurator today and see if that expansion module is orderable. I knew it was on the roadmap but it just wasn't orderable. Thanks again...-MN
We actually did finally figure out the problem with the help of a programmer that Cisco dispatched to the site. It turns out there was a bug in that particular revision of code (3.2.x something) that incorrectly interpreted a certain message coming ...
Thanks for the info... I'll probably end up setting up a few different scenarios in the lab to see what works & what doesn't. For the record, you are VERY right about most of the documentation being ambiguous at best.
Do you have Ethernet bridging enabled? I forget exactly where the "Ethernet Bridging" checkbox is located but I think it is under the AP configuration options. You should only have to have it enabled on the RAP.
Not sure about your AP movement issue but it clearly seems to be related to the "upgraded" legacy APs.I've experienced similar problems with disassociations and roaming clients and the problem was exacerbated by the controller frequently disassociati...
