Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi! I've a wlc with a few light weight APs setup, and the client get connected and authenticated to the lightweight AP through the WLC's Win NPS server. I would like to setup a new autonomous AP with WGB configuration (with the autonomous connected t...
hi! I've a few questions to verify: 1) Is the IOS and boot flash stored in the SUP or chassis.2) If there's a hardware failure below: Chassis failure - will it work by simply slot in the existing SUP and modules into the new chassis? Sup fai...
internet<ASA<Internal LAN>Global WAN MPLS to other siteshi! We've the setup above in our environment. The ASA box is used to establish tunnel to our HQ if the WAN MPLS is down.I've issue managing the ASA box from network (internal LAN from other site...
hi! because of downsizing we are migrating from lease line to internet vpn, and there's possibilty of going for a flat network, because we do not want to mix the Network segment betwee the lease line/MPLS to the Internet VPN site to site IP range.In ...
hi! we've the below setup currently, and we are moving to internet site to site vpn because of downsizing.2x L3 Switches running HRSRP>connected to a router that has a point to point lease line connection to our HQ.The lease line will be replaced by ...
If the replacement sup (exact same model) is a spare unit from our head office that had been used in another retired chassis(same model), will it work if i just swap it if the exisitng unit failed without going through the license activation process ...
hi! is the license activation steps required? I don't remember the vendor did the license activation few years back when a faulty sup was replaced.can i just removed the cf card from the faulty sup, and insert it into the replacement sup (spare sup w...
hi! we are using checkpoint edge, so i would have the L3 Vlans summary address as the destination from the FW through vlan100? do i need to add vlan100 into the L3 OSPF? Just for my info, dont think we are going to do that.we would just have vlan 100...
hi! So in short, there's no need to create the HSRP gateway for vlan 100. I just need to make sure that the FW internal GW is used as the GW when i issued out IP address thru the DHCP. The existing default route will have no impact on vlan100.and In ...
hi! The lease line is to connect site A to site B (which has MPLS connection to HQ). The lease line is used for both internet (eventually exit thru site B) and enterprise network.Here are the answers to your questions1) Yes, until we move all the eq...
