hi! I've a wlc with a few light weight APs setup, and the client get connected and authenticated to the lightweight AP through the WLC's Win NPS server. I would like to setup a new autonomous AP with WGB configuration (with the autonomous connected to a hub, with 2 PC connected), and able to connect to existing Lightweight AP. Need some advise on how to set up the WGB in the autnomous AP. The WLC security configuration is shown in the screenshot attached. Thanks.
I tried this config, but was not successful.
dot11 ssid wgbtest
vlan 10
authentication open eap eap
authentication network-eap eap
dot1x credentials wgb
dot1x eap profile eapfast
infrastructure-ssid
!
!
!
eap profile eapfast
method fast
!
!
!
dot1x credentials wgb
username test\testuser
password 7 xxxxxxx
!
interface Dot11Radio0
no ip address
!
encryption mode ciphers aes-ccm tkip
!
ssid wgbtest
!
antenna gain 0
stbc
station-role workgroup-bridge
workgroup-bridge client-vlan 15