Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello wonderful people,do you know of any tool that can convert ASA NAT details (sh nat details) in a tabular format for better visibility? something like this as an example (see table below).there are tons of lines of code and its will be super over...
hello wonderful people, here is my situation.i have 93180 and its interface 1/25 is connected to cisco asa firewall inside interface. my goal is to capture SPAN all the traffic both RX and TX to destination port 1/23 which is connected to Artic Wolf ...
hello wonderful people, here is my situation.i have 93180 and its interface 1/25 is connected to cisco asa firewall inside interface. my goal is to capture SPAN all the traffic both RX and TX to destination port 1/23 which is connected to Artic Wolf ...
i have cisco 93180 and i am planning to upgrade IOS to nxos.9.3.9.bin.i have connected USB drive and switch has recognized it already but when trying to copy IOS from USB1: to BoolFlash: it get the following error message.file error Destination: Read...
Hello Wonderful people,here is a situation, i have two CAT 3850s switches facing ISPs via BGP and we are receiving default routes from ISP.lately, there were lots of failed login attempts from countries notoriously famous for intrusion and hacking (i...
thanks for all your help VIP Mentor, this link really helped.
i have created a configs, would you please have a look and let me know if this will work?
Switch#1interface Vlan10descriptionno shutdownip address 192.168.1.2/24hsrp 10preemptpriority 110i...
may i get some detail information or any article that can help?
how about static route over vlan like this:
switch# configure terminal swicth(config)# interface vlan 10 switch(config-if)# ip address 192.0.2.1/24 switch(config-if)# ip route 172.10.1....
Thanks a lot for the solution, i have another question regarding the same solution, access switch is the same switch where DHCP clients are residing, so if i create a SVI on access switch, can i define different pool within that SVI ?
this is what i ...
guest shell is not worth the effort and it will be problematic as well for operations team to troubleshoot. furthermore, Guest shell configs are not approved.
Hello All, first and foremost, i would like to thanks everyone who participated in this discussion and provided valuable insight.based on the information provided, i have made a decision that multihoming is being done for a purpose so we can keep thi...
