Hi,I'm doing rspan between two 3750G connected by trunk on etherchannel running version 12.2(44)SE5.I only get receive traffic from the remote span vlan. I have create the remote span vlans and allowed it on the trunk interface on both sides.Switch...
Hi all,I have a requirement to setup a IPSEC tunnel to allow access to remote users to a subnet on inside. The same subnet is already in use elsewhere on the inside network. My vpn tunnel terminates on the ASA (7.2) on the outside interface. I want t...
I see the bandwidth value on the Gigabit interface on CBS3020 is wrong:GigabitEthernet0/2 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is 001b.9005.0c82 (bia 001b.9005.0c82) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 ...
Hi all,I have configured trunk between 6509 and HP C-Class blade server which has two CBS3020 switches. On both the switches I see input and crc errors but no errors on 6509 ports:5 minute input rate 70000 bits/sec, 69 packets/sec5 minute output rate...
Hi,Yes it has, as in one of replies above:switch3#sh vlan remoteRemote SPAN VLANs------------------------------------------------------------------------------4094Thanks,
Hi,Since the addition of switch3, switch 1 and 2 only have the following configured:monitor session 1 source interface Gi1/0/17monitor session 1 destination remote vlan 4094cheers
Hi,I have added a third switch 3750-24P running 12.2(46)SE and trunked to my switch1 allowing RSPAN VLAN 4094 on the trunk. Now my issue is the destination port on switch3 does not receive any traffic, I see taffic coming in on the trunk interface.sw...
Hi,Did you ever find solution to the issue.I have 11503 and I have same problem, I cannot ping the redundant-interface address from the directly connected switch.It works for first few seconds when the CSS reboots or interface bounces then stops.Any ...