Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
by default when you run AD import in UC, it fetched whole AD domain accounts which contains service accounts and a lot other stuff which one don't want to import. So choice is to search using a particular Base DN which query only one OU. But this sim...
I am using 5mbps MPLS over Ethernet connection. Its working fine but I saw many error messages in input and output. Can anyone help me. Sh int fa 0/1 belowyourname#sh int fastEthernet 0/1FastEthernet0/1 is up, line protocol is up Hardware is MV96340...
Mapping one public IP to many private IPs via different ports is normally supported in some firewalls.What about Cisco PIX or ASA? Is this possible that we can configure that if somebody hit public IP 83.232.212.98 on port 8000 then take it to 192.16...
I am using Cisco VPN client to connect our one remote office.Unfortunately the IP pool range defined in remote office is same like my local LAN I mean my LAN is 192.168.1.x and VPN client IP also 192.168.1.x. After connection I can connect remote off...
I have 3 routers connected via fram-relay cloud. I am facing a problem in connectivity because the Hub router is not mapping the spoke routers IP with relevant DLCI but spokes are mapping IP to relevant DLCI to HUB. Below is output of frame-relay map...
Yah dear Rick I did as you suggested, now its working fine. But actually I was looking for the answer that why the same scenario is working in production setup. Amazing.
But my friend my all routers are not able to ping each other. Even I have restarted all routers many times. What do you think about the rburts' replies. He said that your production network is inconsistent, what do you think about his reply . I don't...
