Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi hope someone could help?I'm trying to get a DHCP to my Guest ssid from my access point.The Thing is that when i connect to SSID 1 i get DHCP from VLAN 1 and that ok.When i connect to SSID 2 Vlan 2 no DHCP at all.AP:Operation Mode:Multi ssid Enable...
I would like to know why do my AP is so limited?It looks like i can't do much with that... Info:ap(config)#exitap#? configure Configuration method debug Debugging functions (see also 'undebug') ...
Configure Cisco 871-k9Hallo Everyone,I'm trying to setup a small network with a CISCO 871-K9 switch as my gateway outside and WAN VPN firewall etc' and as my network switch inside the LAN but having a lot of problems to ping to all the clients in th...
Hi Mr. Lereno,Thank you again you are a Guinness.It was the switch that was buried under my desk.Its working now I will set up the Vlan tagging on the switch and i'm doneNow i just need to isolate the SSID 2 on VLAN2 since i can from the guest VLAN...
Hi Mr. Lereno,Thanks again and here it is:Router#show vlan-swit VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Fa0, F...
Hi Mr. Lereno,Thank you again.I do not know if it is a good idea but my vlan2 is Interface VLAN2 and not vlan2.Router#sh vlans No Virtual LANs configured. Jut added the configuration changes that you suggested and i will try this in the next minutes...
Hi Mr. Lereno,Thank you again,The router is a cisco 871.The AP is a TP-Link without cli just a web interface config and it is limited to1. multi SSID that assign to VLAN.2.Here is an emulator for my AP.http://www.tp-link.com/resources/simulator/TL-WA...
Hi Mr. Lereno, Thank you for your quick reply and for being sharp on analysing the configuration.I did change the default-router to 172.16.1.1.I also changed the interface connected to the Access point to:switchport trunk allowed vlan add 1,2 The thi...
