I have a user who needs to VPN out from the internal network of the pix to a site on the internet. I tried settings which do not work. I know I need to allow protocol 50 in, just can'f figure out how to. Any help is appreciated.Things I have tried...
Can you specify the pix to log only a specific IP or protocol? Or does it have to log all traffic, and you go through the whole buffer? What command will be used?thanks
Will a Cisco 11501 Content Services Switch work for server load balancing? I need to load blanace Citrix application servers. If not what other Cisco L4 will work?Thanks
We are working to install 3 floors worth of wireless in our office building, Which AP's would be the recomended ones? From what I take, the only differance between the three is upgradability. Is this correct?Thanks
I tried taking a PIX 501 config, and installing it on a 506E, this did not work. I could not pass traffic in or out of the PIX (translation did not work). Should this be that case? The config works fine on the 501. Below is the config.Thanksnamei...
Thanks for the reply,-I cleared XLATE and ARP tables-Both interfaces were up, as I was able to ping them fron the inside and outside (sho int also showed them as up)Unfortunately I do not have logging output. However does the below message mean anyt...
