pps - packets per second Yes, Its packets coming into interface.It Specify the rising and falling suppression levels as a rate in packets per second at which traffic is received on the port.HTHRaj

Hi Sam,To use ssh you need to do following1. Confgiure hostname and domain name on switch2. start aaa ( aaa new-model cmd this will allow to use local users to login via ssh if no tacacs is configure )3. Generate rsa key ( crypto key generate rsa )4...

Hi,Per-VLAN configuration is supported only on trunks. Since you have configured the interface has access port you can not use the static mac-address statement with vlan vland_id.So its a invalid config.chk this linkhttp://www.cisco.com/en/US/docs/sw...

Hi Krish,Default settings for switchport port security is Aging : Disabled Aging type : Absolute Static Aging : Disabled Since static aging is disabled you can set the aging for dynamic learned MAC usingthe below command Switch(config-if)# switc...