Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI have following situation:Two Core Switches 4500 SW_C01 and SW_C02and some Access Switches SW_A01 ...The Access Switches are redundant connected to the two Core Switches. From the STP point of view we have a standard triangle situation. Proble...
Hi AllI heve a redundant C4500 Core which is connected to Dell PowerConnect5324 Switches. The Dell Switches does support Common Spanning Tree (CST) but not per VLAN STP. My Problem is now, that I cannot find out how to configure CST on the Cat4500 Sw...
I have a VPN Tunnel from PIX to NMS-DMZ.now i want to enable logging on the PIX (on the same as the Tunnel starts) to the NMS, but it seems that the packets are not entering the tunnel. how can i route the Packets into the tunnel?thanks Phil
Hi from an 5505 Switch I regulary receive a sysConfigChange-trap once a day. The trap discriptions says me this was a Configuration Change who triggered this trap, but nobody is configuring this Switch (every night). So what are the reasons to send t...
I run CW2000 with RME 2.2 on Solaris 2.6 on the same Server as OP-OV NNM.while opening a task who requires the selection of some Devices the Browser hangs (with no Error message) while loading the Device List.this Problem does not accure after reboot...
Thanks to all of you!I learned a lot in the meentime:PVST is the mode to use with devices which runs CST only (as Francois explained in detail)And MST using on Instance gives you an unic STP (also as explained from Francois)The Instability i had was ...
Hi allWas there a solution for this Problem found?I have the same Issue: Failoverlink is OK, synchronisation is OK, Failover while powerdown is OK, but Link status is shown as unknown.Any Solutions??regards Phil
Yes I want to Listen to Syslog Messages to retrieve Cinfigs if changed.What I do not understand is why do I receive a sysConfigChange (on NNM) if nothing is changed?Its possibly, that CW2000 is getting the Config causes this trap, but then I missunde...
