Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using a little 1811W to test multicast routing.There are 2 VLANs configured (3 & 4) attached to 2 BVI interfaces. There are separate wireless SSIDs attached to each VLAN. There is a Loopback, which is configured as the static RP address. PIM spar...
We have a number of web servers behind CSS11500. We would like to be able to send an http redirect to a client browser, depending on the client's IP address.I had thought this might be possible using ACL but I can't find anything that seems to fit th...
I have a CSS11501 with a certain 10.X ip address on the management interface.Even if I add routes to the CSS config, I can access the management interface only from its own subnet, i.e. I can't access it from across a router.Is there a way of applyin...
I have 2 Cat6509s in Hybrid mode (CatOS 8.5(1) IOS 12.2(18)SXF) and Sup720-3B.These have a number of layer 2 Vlans configured, most of which have corresponding L3 Vlan interfaces on the MSFC.Both are VTP servers, so the L2 Vlan config on both is iden...
I have a 1760 router with 96MB DRAM. Is there a way I can find out, without opening the router up, (1) how many slots there are for installing DRAM; and (2) which of the slots are occupied with DRAM and which are free?
Thanks for your reply, but neither of those URLs really seem to address the specific problem I have. And in any case, I'm not using the IOS firewall described in your URL, but the zone-based policy firewall. All the interfaces over which I'm trying t...
Hi JoshI had to solve a very similar problem to yours, and the solution I came up with was to use L2TPv3 (layer 2 tunnelling protocol) over IPSEC. I used the same device (a pair of old 1700 series routers at each end) to create both the L2 tunnel and...
Sorry, I just read the details at http://www.cisco.com/application/pdf/en/us/guest/products/ps792/c2001/ccmigration_09186a0080292895.pdfso thanks anyway!
Hi, thanks for your reply. I have already looked at that page. I was just wondering if I could upgrade the RAM without having to discard any SIMM/DIMM which is already present.I guess I'm just going to have to get the screwdrivers out
