Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We need to bond together two 100Mb Ethernet circuits between our company and a customer. The only traffic the bonded circuit will see is a single VPN between our firewall and the customer firewall. With only those two IP's, or the two MAC addres...
Hi,I hate these little phones with a passion but someone approved purchasing 75 of these guys and were stuck supporting them. There at one site that run CME version 9.1.. the phones are running firmware...9-2-2ES1... this firmware fixes the timezone...
Hi,Is it normal for calls to use channel 23 as a B channel? I've never seen this before.. Bearer Capability i = 0x8090A2 Standard = CCITT Transfer Capability = Speech Transfer Mode = Circuit ...
Hi,We have a 2811 thats currently running four T1's in a multilink bundle.. no other services running like NAT, ipsec etc. We need to upgrade the bandwidth and the cheapest is to add four more T1's to the bundle. From looking at the docs the 2811 w...
Hi,We have a couple of autonomous 1262's that I'd like to get configured. I would like to put the Ethernet interface out on our Internet subnet and have theclients get a RFC 1918 address from the radio's. Our little Linksys is setup this way and th...
Bill,Looks like you just assign the ports to a vlan. http://www.cisco.com/en/US/docs/routers/access/1800/1801/software/configuration/guide/dhcpvlan.html#wp1021995Mike
Hi,Lots of things to check..start at the PC and server and work your way to the router. Is the PC and server in the correct vlan and showing link? Are the IP addresses and subnet masks correct on the systems and router? Are the trunks up between the...
Leonardo,The TAC engineer said it affects 3905 phones on CME and CUCM. She also sent me the engineering special version of the firmware. The firmware is 3905.9-2-2ES2.Good Luck!Mike
