About josephbruce

josephbruce · 05-04-2006

Is it possible to copy the startup-config file to nvram under a different name to have as a backup?I will be updating a config on a router, and if I lose connectivity to it, I want to be able to tell a non-tech in a few simple lines to restore the st...

josephbruce · 05-17-2006

If I remember correctly, T1 voltage (true T1) is 130VDC. If you have several fried WIC T1 cards, call Telco and advise them that they need to replace the NIU (SmartJack). Inform them of the mulitple interface cards that have been burnt out.Telco wi...

josephbruce · 05-17-2006

cisco AIR-AP1231G-A-K9 (PowerPC405GP) processor (revision A0) with 14838K/1536K bytes of memory.Processor board ID FOC09501XL4PowerPC405GP CPU at 196Mhz, revision number 0x0145Last reset from power-on1 FastEthernet interface1 802.11 Radio(s)That ...

josephbruce · 05-17-2006

When the ckt vendor stated the ckt was good to the dmrk, the question is ....Who owns the external CSU?Also Telco's will state good to the dmrk when they loop the NIU (or CSU if telco owned).If telco owns the CSU, replace the cable from CSU to router...

josephbruce · 05-17-2006

First verify that the radio module is physically installed in the AP.Second, what IOS are you running? Or is it VXworks?

josephbruce · 05-12-2006

{Would this be the same for any network starting 172.30 etc ? and if I had sat a 192.228/16 network and this wants to find the 192.228.1/24 netwrok, will this do the same thing ?}You can NOT (or at least SHOULD NOT) do that with the 192 network, as t...

Member Since	‎06-09-2005 02:44 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	10

User Statistics

User Activity

Backing up start config on NVRAM

Re: VWIC surge protection

Re: 1200 AP missing radio interface

Re: Troubleshooting Physical errors in a Frame Relay Environment

Re: 1200 AP missing radio interface

Re: overlapping networks