Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a 9130AXE AP I want to configure as Embedded Wireless Controller, I have followed the documentation, so far I have1. Downloaded 9800-AP Universal zip file which has the required files and images2. I have factory reset the 9130 AP, an...
I am trying to install Cisco ISE in my lab, I tried to download the evaluation version of ISE (version 3.1) but it is a OVA file and I use Hyper-V.Since hyper-V does not support .OVA filesDo I convert the OVA file to VHD to import into hyper-V or dow...
@CoachChan this reply may be coming in a bit late or may not be the solution to this but I also got the same DTLS error, turned out to be an issue with VLAN, the uplink switch from which the switch the AP is connected did not have the vlan needed for...
@Mark Elsen, thanks for the link sharedas part of the requisites, there should not be any WLC in the network during setup of EWC, I'm guessing this may be an issue, although I don't expect it to affect it the new AP from being reached by any device i...
Hi @Flavio Miranda Currently on a 8-port C1000, check power-inline, AP is consuming 30wattsThe switch configs:defaultinterface GigabitEthernet1/0/4switchport mode trunkendusing Management vlan (vlan 16) as native vlaninterface GigabitEthernet1/0/4swi...
Hi Mohamed,I just re installed on hyper-v, I selected generation 1 during setup this time, and it worked, that's the only change I made between the two VM setupsBut I still have issues transfering files via sftp too, I will look into that in soon tim...
