Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having issues with getting an etherchannel between a 2821 (on-board giga ports) and 3750. I have followed the config shown in the Cisco docs but can not ping the devices, and when I do a Show etherchannel command on the 2821 no ports are shown a...
I have a 2811 with a WLC6 installed. I have logout of the CLI and I am stuck in the user login page. How do I get back to the Routers CLI with out rebooting the whole router
I have had a problem while uploading my cat 3750 with new IOS image. I have had to upload .bin file via xmodem (!! very slow) when issue the boot command get error switch: boot flash:c3750-ipbase-mz.122-25.SEE.binLoading "flash:c3750-ipbase-mz.122-2...
have tried the second method, had problem iwth the upgrade tool, I have no Cert on the LWAP so it keeps rebooting. when I do the TFTP path get this error"button pressed for 23 secondsprocess_config_recovery: set IP address and config to default 10.0...
