Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently purchased several 3702i LightWeight APs. These shipped with Software version 15.3(3)JD
Our 5508 WLC is only running Software Version 8.0.140.0 , which is not compatible with the Software on the new APs.
Unfortunately, The WLC cannot be upg...
I have a 1841 running IOS 12.4(17). Int fa0/0 output packets is showing unknown protocol drops. What does this mean and is there a way I can see what protocol/ports the drops are occuring on?
Just installed a 2960-24TC switch with a GLC-GE100FX MOdule. This uses 100MB Fibre and connects to a 3550 Switch. 3550 is set to Full Duplex.Any ideas why the GigaBit Interface on the 2960 would be detecting at half duplex? This is causing some late ...
William, most of the info is in my Initial post.
access points are 3702i
Wlc is 5508
Legacy are older Cisco APs, but that's irrelevant as we just need to know the WLC cannot be upgraded.
I just need to know if we can downgrade the APs without needing...
This is simply from the sho int fa0/0.FastEthernet0/0 is up, line protocol is up0 output errors, 0 collisions, 3 interface resets1694079 unknown protocol drops0 babbles, 0 late collision, 0 deferred0 lost carrier, 0 no carrier0 output buffer failures...
The 2960 will not allow the speed or duplex to be changed. The duplex was changed to auto on the 3550 and the link stayed at 100 1/2.I had to add the media-type sfp command to the Gi0/1 interface and then I was able to modify the duplex setting as ou...
