Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using a cisco 2621 with fw feature set as a firewall between out department network and the university backboneAround the end of May there was change in the campus backbone that put a number of vlans into a flat network resulting in large increa...
I have a 3750 configured to do inter-vlan routing. There are 4 vlans.when do a sftp file transfer from hostA on vlan3 to a hostB on vlan2 I only get about 1000kB/sec to 2000kB/sec.the hosts are connected on downstream 2950 switches on the appropriat...
Based on my config I expect to see logging of access to my 2621 router when I ssh to it. However no such records appear in the log file. What's wrong?I am getting other messages in the log files.logging trap debugginglogging facility local5logging ...
I currently have a 2621 router (with firewall feature set) configured with virtual interfaces to connect (using vlan trunking) with my switch which has 3 vlans, vlan2(students), vlan3 (faculty), vlan4(research).Current access-lists on the router allo...
C2600 Software (C2600-IK9O3S-M), Version 12.2(6)I see that others solved this by increasing the high and low values but I don't think my router has enough memory to go much higher and I can add any more memory. That's why I though a 2821 would solve ...
that did not help eithermelayer3#sho sdm prefer The current template is "desktop routing" template. The selected template optimizes the resources in the switch to support this level of features for 8 routed interfaces and 1024 VLANs. number of unic...
with regard to the L3 interface with a 30 bit mask to connect to the 2621 does the choice of the ip address matter as long as the static routes match up?for example let say I choose192.168.10.1/30 for the 3750 interfaceand 192.168.10.2/30 for the rou...
