Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone experienced high output drops on IE-4010 interfaces connected to VMware Hosts & also the uplink to the core switches from the IE-4010? Lots of chatter about buffer issues but need to narrow this down.
We have some of our VM Hosts connected...
Hi There,I have 2 C9500 L3 switches setup successfully authenticating to 2 ISE 2.6.0.156 servers using the following command set:aaa group server tacacs+ ISE_SERVERSserver-private 10.x.x.1 key 7 blablablaserver-private 10.x.x.2 key 7 blablablaip taca...
Hi there,I am attempting to do a trace route from a switch to an interface I have on a my ISE server however it is getting blocked. Does ISE (v2.6.0.156) have some sort of firewall that could be blocking the trace attempt? Thanks!
Hi All,Not sure why I haven't done this previously but I have just enabled the tacacs debugging. See results below when I try to logon with tacacs enabled in the switch config.009236: Apr 16 15:30:17.538 UTC: TPLUS: Queuing AAA Authentication request...
Hi @balaji.bandi, the 'private-server' commands are working on any of the L2 switches, no matter which model it is (IE5K & 4010). On the IE5K's that have routing enabled it doesn't work & I have to use the 'tacacs server' commands which do work.
Hi @MHM Cisco World - no problems mate, any help from you guys is greatly appreciated!1 - No VRF's are used2- C9500-48Y4C running Cisco IOS XE Software, Version 16.12.05b (working with aaa group server tacacs+ ISE_SERVERS ISE config)IE-5000-12S12P-10...
