About Nancy Saini

Nancy Saini · 12-11-2019

Is there any way we can add a new vendor shown in the Vendor list while creating a new Network Device Profile.

Nancy Saini · 05-11-2019

Hi Team, One of the AnyConnect document mentions that due to architectural changes on Symantec products, the remediation is not supported. Would like to check on what version of AnyConnect will it be supported. Thanks

Nancy Saini · 04-28-2019

Hi Team, Just wanted to know the AES and SHA key length supported on ISE 2.4 for SNMPv3 Regards, Nancy

Nancy Saini · 04-15-2019

Hi, Is server based TLS 1.2 supported on ISE 2.4? The release notes mentions only about client-based TLS 1.2 : https://www.cisco.com/c/en/us/td/docs/security/ise/2-4/release_notes/b_ise_24_rn.html#id_82769 Regards, Nancy

Nancy Saini · 12-05-2018

Hi Team, As per ISE-PIC performance document : https://community.cisco.com/t5/security-documents/ise-performance-amp-scale/ta-p/3642148#toc-hId-1418220509 maximum syslog providers we can configure are 70. Is there any way to relax the syslog limi...

Nancy Saini · 05-25-2023

Based on the description provided, WLC is first contacting the 2.4 deployment. Can you check what is the first PSN defined on the guest SSID? If that is not the case then enable client debugs on the WLC and check why the RADIUS request is going to i...

Nancy Saini · 05-25-2023

Please check below pointer on ISE: Are you able to reach the default gateway of eth1 from ISE?"show interface" output from ISE. Check the status of eth1 and also check if RX and TX counters are increasing when pings fail.While pinging eth1 from a PC,...

Nancy Saini · 05-12-2023

Get the output of "show logging system ade/ADE.log tail" while doing the upgrade. Also, the logs you have shared seems to be of application upgrade proceed and not application upgrade prepare.

Nancy Saini · 05-11-2023

Could you share the SGACL policy enforced on VLAN list 200? Also, what is the SGT for source and destination here?

Nancy Saini · 05-11-2023

The node on which the certificate is installed is the one handling the authentication request, right? If yes then maybe the change didn't get reflected at the DB level. Can you try reloading the node and check?

Member Since	‎08-30-2017 12:00 AM
Date Last Visited
Posts	65
Total Helpful Votes Received	41

User Statistics

User Activity

ISE : Add new vendor for network device profile

ISE 2.4 : AnyConnect support for Symantec AV 12.x for remediation

ISE 2.4 SNMPv4 AES SHA key length support

ISE as a server with TLS 1.2

ISE-PIC Syslog provider limitation

Re: [ 400 ] Bad Request,The request is invalid due to malformed syntax

Re: Multiple interfaces on ISE for Radius/Guest portal

Re: Stability of ISE version 3.2?

Re: VLAN SVI unreachable after enabling CTS VLAN enforcement

Re: ISE sends the old self-signed certificate instead of the newly one