Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I want to limit the bandwith usage on my E1 to 1mb for any traffic.Do i need to apply rate-limit command to input an output traffic both ?what should be the values for bps burst,normal burst and excess burst in the rate-limit commands ??All i ...
Hi all,I have a 2mb link.I want to rate-limit Voice traffic to 1mb and the rest 1mb for Data on the serial int.Please advice me what's the best possible way to do this.I am looking at CAR and CBWFQ and a bit confused.
Hi All,Im having a 2mb MPLS link on the local end and on the remote end,I have 2 T1's (1.5mb each).Im having issues with the T1's at the remote end.The incoming traffic on the T1's appears to be normal but the outgoing traffic is not load balanced an...
Hi All,I have Ayaya phones connected to 4507R Version 12.2(20)EW1 and on the Fe interfaces,im receiving too many Runts and Input & CRC errors.I really not sure why Runts are being generated.Im pasting the config.would appreciate any help in this rega...
Hi All,Im having issues with one of our T1's.Im seeing the reliability going up and down on the interface due to which there are too many carrier transitions and lot of input and crc errors are being generated.The other end router shows up clean.I ha...
U can try Solarwinds which can get u all the graphical as well as tabular description of the usage and the bandwith gauges can get u the actual load at all times.Hope it helps..
It means my values would be smething like:rate-limit input 1000000 187500 375000 exceed-action drop.Wud this help me achieve my purpose ? I want to cap at exactly 1mb..no more.no less
Sorry.The requirement is to limit the bandwith usage to 1mb,be it any traffic.Im still confused bout the rate-limit parameters (bps burst-normal burst-max) as i need to specifythe total or the max to 1mb.
Im posting you this link..hope it helps.http://www.cisco.com/en/US/products/hw/modules/ps2643/products_tech_note09186a0080093fc5.shtmlhttp://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a00800a7b80.shtml
Hi,I dnt see any harm in enabling rtp header compression at the Multilink int. as it wud be the voice packets that wud get affected even if data an voice move together.Mreover you can enable tcp header compression also.You can also define LLQ for voi...
