Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Problem:I am trying to setup my Cisco 1721 to route traffic from a WAN to two Ethernet interfaces where one is a DMZ and the other is a trusted LAN with NAT. I am having trouble getting the correct configuration built that allows both the DMZ and the...
Hello,I'm working on an experiment where I can get around bandwidth throttling. For simplicity in reading, I will refer to the “throttled network†as the ISP and my connection to the ISP as WAN.The ISP controls the throughput of each network conn...
I am having an issue with DHCP. I am using a cisco 1710 (one fastethernet and one ethernet) on my network. I live in an apartment where my ISP provides me a direct ethernet line to them. Everyone in the appartment gets an ethernet line. The ISP runs ...
There is a command that will give the console port high priority so that I can access it (with hyperterminal) when the router is under heavy CPU utilization. I have been looking on Google for the last hour and can't figure out what I searched for las...
Recently, my ISP disabled my internet connection. I was told because my router was sending out ?funny? traffic on their network. They could not tell me exactly what the traffic is, but they said it was my IP address broadcasting itself on their netwo...
rrowlandkumc:Static NAT port mapping is my next step. My current step is figuring out why hosts in the trusted LAN have web access to the internet while ones in the the DMZ don't.As in, I'm on a workstation under each Ethernet interface trying to go ...
Thank you for your reply. I have added your configuration to my router. When I enable the same debugging as before, I only get:*Apr 8 11:52:47.550: DHCPD: checking for expired leases.*Apr 8 11:54:47.550: DHCPD: checking for expired leases.*Apr 8 1...
Rick,The only thing connected to the hub on my side is my laptop and the router. Now, when I sniff, I see a lot more stuff then I should (IPv6, AIM, HTML,UPnP) from other IPs. It appears (maybe?) that my ethernet drop runs to a hub and not a switch. ...
Rick,No, I do not see anything from my provider. All I have is just what is in that screenshot at http://www.pcexhaust.com/cisco.jpgMy sniffing doesn't seem to be picking up everything like it was a few nights ago. In my current setup, I am using a h...
