About rommel-peraza

rommel-peraza · 01-09-2014

Hi there, I am having an issue with OSPF adjacency going down because of BFD triggers a recalculation, there is no indication (logs) of any other event as flapping interfaces, CPU or traffic spike.Message:OSPF-5-ADJCHG 1149: Jan 9 00:03:09 EST: %OSP...

rommel-peraza · 11-24-2008

Hi, I have 2 routers 2801 with the console port completely broken (due to an electrical failure in the office a few weeks ago). Is there a procedure for "rescue" those devices?

rommel-peraza · 11-08-2007

I have a problem with an ASA, at start up, the Status led remain ambar and I can't connect to the console. How can i fix this? or where can i faind the info?

rommel-peraza · 09-17-2007

Hi,where can I find information about how to use the CME logs for make reports of calling statistics and billing?

rommel-peraza · 09-16-2007

Is there a way to configure the Anti-X module such as I can filter the web content based on source VLAN or subnet? I need to implement something like that and can?t find how to do it.

rommel-peraza · 01-28-2014

Hi Madjhu, Did you have a chance to check this out?Thanks,

rommel-peraza · 01-15-2014

Madjhu, There is no CoPP configured on the ASR1K to protect bfd packets. What else could we use to protect them?Yes, BFD flapps only occur on the ASR and then OSPF flapps too.No OSPF messages are shown on the N7K (no logs at all on those days, actual...

rommel-peraza · 01-13-2014

Madhu, I was wrong before, on the N7K we do have CoPP and BFD is in hardware on that device.

rommel-peraza · 01-13-2014

Hi Madhu, Thank you for taking the time to review this. BFD is on software, it has hapenned only twice so far, last Wednesday night and again on Friday night (non usual high trafficc hours). No BFD or OSPF messages are shown on the N7K. We don't have...

rommel-peraza · 02-09-2012

Hi, I was looking for some help on configuring a Juniper FW on my Cisco ACS v4.0 and I found you guys. Can you tell me which would be the best way to do that or where can I find good documentaction about it?Thanks.

Member Since	‎02-09-2005 05:35 AM
Date Last Visited	‎07-27-2018 12:07 AM
Posts	20

User Statistics

User Activity

OSPF adjacency down due to BFD node down

Configure a Router 2801 with the console port borken.

Ambar Status LED on ASA 5505

CME accounting and billing

ASA Content Security Module (Anti-X) issue

OSPF adjacency down due to BFD node down

OSPF adjacency down due to BFD node down

OSPF adjacency down due to BFD node down

OSPF adjacency down due to BFD node down

ACS 5.2 - Adding Custom Attributes for Juniper Netscreen TACACS+