About petersmiddy

petersmiddy · 06-29-2024

We use a network-centric design. My end goal is to get an idea of how many VLANs (EPG's) & VRF's, as well as how many L3Out uplinks (routed interfaces and SVI's) there are in an existing Tenant. For the L3Out uplinks I think I just need the tDN under...

petersmiddy · 05-22-2018

Hi all,I'm stuck with a problem on ACI Programmability Options lab, section APIC Sandbox Environment Setup:https://learninglabs.cisco.com/modules/intro-to-aci/sbx-intro-aci-02_programmability-options/step/1It says:####################################...

petersmiddy · 12-15-2014

Cannot clear dynamic nat translation- getting %Translation not found despite translation being there0055-EC-Choke-sw1#sh ip nat trans | inc 10.98.226.90 gre 146.150.3.1:1044 10.98.226.90:594 ...

petersmiddy · 02-09-2012

Trying to calculate how many end-users would be able to pull down data at 100Mbs each from a Server that has a 1Gb connection to a WS-X6748-GE-TX card, presuming worst-case scenario in which every user would be maxing out their respective 100MB conne...

petersmiddy · 06-30-2024

@RedNectar - Thank you so much for the prompt response! I was getting no output at first, but then read more of your blog, and figured out I need to do an icurl -ks , I am getting exactly what I was after. I'm going to compile this information, and...

petersmiddy · 10-05-2018

The learning lab I'm doing is : https://learninglabs.cisco.com/tracks/aci-programmability/intermediate-aci-prog/sbx-intermediate-aci-00_webarya/step/1

petersmiddy · 10-05-2018

I have the same exact problem, here are the steps I took before encountering the error during the baseline.py run, last part of "how to set up your computer" that I followed was to install the acicobra/ acimodel .eggs which worked fine per pip freeze...

petersmiddy · 10-05-2018

Hello all, so what is the fix here? I am running into a similar issue within the 1st page of the Intermediate ACI Programmability module I run the baseline.py script and I get the following , looks like it is not able to import anything in the cobr...

petersmiddy · 12-17-2014

thanks Mosheen, still getting %Translation not found: 0055-EC-Choke-sw1#clear ip nat trans tcp inside 146.150.3.1 1044 10.98.226.90 594 outside 50.73.193.25 594 50.73.193.25 1044%Translation not found0055-EC-Choke-sw1# 0055-EC-Choke-sw1#0055-EC-C...

Member Since	‎12-01-2003 07:13 PM
Date Last Visited	‎07-01-2024 01:07 AM
Posts	11
Total Helpful Votes Received	1

User Statistics

User Activity

How to get EPG's, VRF's, L3Out uplinks, and Leafs

ACI Programmability Options- Devnet Lab- Stuck on Step 1 :(

cannot clear dynamic nat translation- getting %Translation not found despite translation being there

WS-X6748-GE-TX question...

Re: How to get EPG's, VRF's, L3Out uplinks, and Leafs

Re: Sandbox Learning Labs issue - ACI Programmability Options

Re: Sandbox Learning Labs issue - ACI Programmability Options

Re: ACI Learning Labs problem

thanks Mosheen, still getting