Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an AP 9120 that i boot looping seems it can not find the file Part.bin, so wondering if there is a way to recover from it?
Hit ESC key to stop autoboot: 1 MG link 1G 0Mounting UBI device bootfsubi0: attaching mtd3ubi0: scanning is finishedub...
I have a Basic rate ISDN line provided by BT which is actually two ISDN2e boxes tied together to give 4 channels instead of the usual 2 and it has 9 DDI lines. The problem is now that the siganlling on this line according to BT is set to T.Ref (point...
I noticed one interesting thing which is below >> "Run from flash/host/tftp (f/h/c) : f"full output below and I could not work out how to set it to boot from TFTP as the it would suggest that is possible if the flash is currupt
u-boot>u-boot>u-boot>P...
So out of two AP9120AXI's I managed to recover 1 whilst the second has corrupt flash so that needs an RMA. Spent all morning doing a number of things.
1. first tried the cisco document
Repair C9120/C9115 Access Points from U-boot - Ciscohttps://www....
Unable to load image from UBI PARTITION part1Giving up. Rebooting...resetting ...
Resetting board...e▒▒▒▒\J▒/▒▒mH▒▒HELO5.0205HNDRC1a-1.0.38-163.162CPU0
as you can see from the above it does not get far enough to start doing CAPWAP as it can't fin...
Hi Thanks for the reply
What this does is delete the partition but there is no instruction on how to put the file back on that partition which in this case is "part.bin". So delete the partition and then with no file or an option to download the file...
Hi thanks for the response. The link you sent links to a page that asks the question how to use the usb to boot however I did not see an answer to the question there? In my search I found an option to select boot mode via tftp but now can't find that...
