Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I need a POE cable of 40 meters between the 1310 bridge and the power injector.I found this reference: AIR-CAB100DRG6-F.It's OK for a 1310?Thanks,
Hello,I want to do this configuration:Site A must be connected to site B and to site C. On the site A there is an AP 1230AG, it's configured in bridge mode in point to multipoint to site B and C in 802.11A.On the site B there is an AP 1230AG, it's co...
Hello,I have a switch 4507 configured in level 2. It transports only the vlans. For needs for security the inter-vlan routing is made by a firewall. It is possible to configure the 4507 in server Dhcp for only one vlan without routing inter-vlan on ...
Hello,I have a pix into V7.0(2) with a vpn client in 4.7. The configuration is:group-policy clientgroup internalgroup-policy clientgroup attributes vpn-idle-timeout 30crypto ipsec transform-set myset esp-des esp-sha-hmac crypto dynamic-map cisco 1 se...
Hello, I have a pix 515 in V7.0 version. I must make Nat Destination for PCs in inside. I must nat destination of a public addresse (public1) to an other public addresse (public2). This translation functions correctly,with "static (outside,inside) ...
Hi Rob,The AIR-CAB100DRG6-F cable Length is 100 ft. (30m), do you know if it's possible to interconnect two cables to make 60m or if it's possible to manufacture its own cable?Thanks,Herv?
The problem met it is that I have PCs which have a bad address IP (public1) of smpt server in their smpt client. To prevent modifying the configuration of the PCs a translation is installation so that when these PC send a request smtp, this one is se...
