Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anybody else loaded 7.2(4) on an ASA? I went from 7.2(3)16, and thememory usage jumped from 74.8MB to 91.2MB (20% for a pretty minor version change)
I have a pair of ASA firewalls running in active/standby config. What is the Cisco recommended way to do a gracefully fail over to the standby unit (for example, when doing software upgrades, etc). Rebooting the primary is my current method, just ch...
I have two ASA5520s, both running 7.2(3) in an Active/Standby cluster. Since moving them to 7.2(3) it appears to me that the Standby unit is leaking 100kb of memory every hour; it was up for 5 days and suddenly started complaining about being out of ...
With CatOS (on a 4006 or 6500) how can I see a port's usage? I want to know how much traffic has flowed over the given port recently, (like 'show int vlan1 | inc rate' for IOS). I know I can do SNMP-based graphing, but that isn't what I'm looking for...
I need to sniff some traffic that flows into a 2691 router and then to a Cat2948G-L3 switch (and then to a PIX firewall, where the firewall is blocking it). I don't see a way to do SPAN'ing on the 2948G... is there a way to do this with the 2691, or ...
Is your ASA the default gateway for your LAN? If so, then you should be OK. If not, then you'll need to add a static route on your LAN's default gateway to point the new subnet to the ASA (assuming you aren't using a IGP [RIP, OSPF, EIGRP, etc])
The 501 by itself won't filtered based upon URL, but it can ask a Websense or other system about the URLs, and allow/deny web traffic that way. Check the 'show version' of your PIX and see if you have the "URL-filtering" enabled or not. See http://ww...
