I have a Cisco 1811 with a Satalite internet link on the FE0 and a backup cell modem on the FE1. Both are DHCP. In my FE0 I have backup interface FE1. My NAT ACL1 is 10.x.x.x (internal network)permit any any, and the second NAT ACL2 is the same. ...
We too are experiencing this problem, however for us the problem occurs with users that have multiple sessions going at the same time but only primarily use one session so the other two sessions sit idle for anywhere from 15-30 minutes before they sw...
Thanks Steve, that better clarifies what I mean. The routemaps and nat statements should get him going. Also this gives me an idea for a problem I have elsewhere.Thanks again.
Don't think it will help but here is my config on an 1811W, I have also set this up on an ASA 5510 using the same method but have found that I had to add static routes for the VPN tunnel's endpoint LAN subnets pointing them to the IP of my primary IS...
