Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,My questions regarding Cisco 7500 series router, due to design and redundancy requirements we need to cross 4 7500 (2-7507 and 2-7513) routers with each others via Giga-Ethernet interfaces, so I have to install 2 Giga-Ethernet interfaces on ...
Dear All,Anybody know the contact address for Cisco NetPro forum!! i need to report vert strange issue happened in my profile, so if anybody know such contact please help.Best Regards,Mounir Mohamed
Dear All,I have one Cisco gear (7204-VXR NPE-300)used to terminate around 1500 PPPOA and PPPOE ADSL customers, but Decide to replace it by Cisco7206-VXR NPE-G1 for more bandwidth and sessions, but we faced a very weird behavior, the customers login a...
Dear All, I have centeral Firewall (PIX535) in HQ peering via IPSEC tunnles with other 3 branches, all branches using Cisco 1700 with IOS feature set currently there is IPSEC tunnel between each branch and HQ FW, i need to configure the centeral FW t...
You can boot the new image via TFTP for testing before delete the current image.boot system tftp imagename.bin x.x.x.xmake sure your RAM will meet the image req (www.cisco.com/go/fn), also use a secondary boot statement pointing to the current image ...
By default free or unallocated bandwidth available for overhead and best-effort traffic which is handled by the default-class (class-default) so Yes if you use this command the reset of bandwidth will increased and so class-default will use more band...
Hi,Here is an example, below we have 3 different classes (HTTP/FTP/ICMP)in addition to the default class, i will allocate 500k for each class and only 44k for the default class,since CBWFQ can not allocate more than 75% of the interface bandwidth the...
Hi,The sum of all bandwidth allocation on an interface should not exceed 75 percent of the available bandwidth on an interface. The remaining 25 percent of bandwidth is used for overhead, including Layer 2 overhead, control traffic, and best-effort t...
Hi nikuhappy2010,A lot of techniques available for load-balance, so if you would like to share your topology and requirements or even more clarification about your setup i will be grateful.Best Regards,Mounir Mohamed