About Baratheon

Baratheon · 03-06-2024

Hi everyone,I have a Cisco C9500-48Y4C Switch, but I forgot the login credentials while configuring it, which has resulted in me being unable to access the Switch. Could you please guide me on how to reset this Switch? Alternatively, if any of you ha...

Baratheon · 01-20-2024

Hello!!In my network, I have four routers (R1, R2, R3, and R4), and I am utilizing BGP for routing.The objective is to ensure that all traffic from R4 to the destination 8.8.8.8 follows the path through R3 as the primary route, with R2 acting as the ...

Baratheon · 11-04-2023

My company's data center is currently using a Cisco C9500-24Y4C connected to an ISP router x670 extreme.We've configured a port-channel with 4x 10G ports, divided into two VLANs (VLAN2 and VLAN3).Our BGP configurations are identical on both sides, a...

Baratheon · 03-14-2023

Hi! ! Dear friends, I have encountered a problem here, I would like to ask for your help, and use your experience to guide me to solve the problem. The situation happened like this, on the night of March 13th, my cisco Nexus 3548 Chassis suddenly had...

Baratheon · 03-09-2023

Hi, friends, I would like to ask about the ACL settings. In the picture, I want both R1 and R2 to be able to ping the IT Router, and The IT Router cannot ping R1. I would like to ask you the specific ACL configuration method? No more trouble to guide...

Baratheon · 01-22-2024

Additionally, I would like to ask for your assistance. If I am operating from the R1 router (with the network topology modeled from the perspective of my company), how should I configure the commands? Kindly provide guidance, and I sincerely apprecia...

Baratheon · 01-22-2024

Thank you for your reply. I will attempt to configure the instructions you provided. I have a question to ask: in the instructions you provided, should it be "R4(config-router)# neighbor 24.24.24.2 route-map MODIFY-AS-PATH out" instead of "R4(config-...

Baratheon · 01-22-2024

Thank you for your reply. I will try to configure the instructions you provided. If there are any further questions, please guide me. Thank you.

Baratheon · 12-01-2023

@Torbjørn Thank you for the substantial assistance and valuable tips I received through our discussions. I successfully achieved the ultimate outcome of load balancing. Thank you.

Baratheon · 11-13-2023

@Torbjørn Thank you for your response. Please allow me to continue the discussion with you.#show etherchannel summaryFlags: D - down P - bundled in port-channelI - stand-alone s - suspendedH - Hot-standby (LACP only)R - Layer3 S - Layer2U - in use f ...

Member Since	‎10-06-2022 07:41 AM
Date Last Visited	‎04-03-2024 12:05 AM
Posts	28
Total Helpful Votes Received	1

User Statistics

User Activity

Reset and Login Issues with C9500-48Y4C Switch

AS-Path Modification on BGP Neighbors

Port-channel+eBGP Load Balance traffic problem

All Ports Move to a Hardware Failure State 2023/03/13

packet tracer ACL

Re: AS-Path Modification on BGP Neighbors

Re: AS-Path Modification on BGP Neighbors

Re: AS-Path Modification on BGP Neighbors

Re: Port-channel+eBGP Load Balance traffic problem

Re: Port-channel+eBGP Load Balance traffic problem