Hi,
I've got a problem on my infrastructure. I often have some spanning-tree recalcul.
This morning again, my network crashed. All my switchs were Down in Centreon (ping lost).
TESTS-RZ5-1.1#show spanning-tree detail | i from|exec|occur MST0 is exec...
Hello,
I don't understand why my counters are 0 on all my vlan Interfaces (my vlan routing is working, there is traffic) :
For exemple :
Vlan2170 is up, line protocol is up , Autostate Enabled Hardware is Ethernet SVI, address is Description: Srv...
Hi,
I'm trying to reset 2960X, but when the process is complete, my switch has already some old configuration line like the switch number.
I follow the method with Mode button (http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960xr/hardwar...
Hello,
we juste bought new c6807-xl-s2t-bun, but when I started it, I was in ROMMON mode.
This product is sold without iOS?
Witch one download? Full Encrypt or NPE? What's the difference?
I read there is a specificity for some country to choose one ...
Hi,
I want to stack 5 switchs (4x3750G and 1x3750X) but I've got only 0.5m cable stack.
Can someone tell me how I can connect my 5 switch.
I can't connect the first to the last with 0.5, it's too short.
Thank you
Hi,
I have same problem on 3750G.
I reloaded in ROMMON mode. The command SET show a lot of parameters and SWITCH_NUMBER=2
unset SWITCH_NUMBER
boot
when the boot finish, my switch is number 1 again, but I think switch 2 renumber 1 is the same.