Hello Gents,i have already up and running Cisco SD-Access fabric. but i need to change ip add for lo0 for border/control node.is this possible ,if yes how ?i'm using DNAC Version 2.3.5.5
hello all.i have 2 cat 9407 with sup-1 XL configured as border/control node with stackwise virtual.i need to replace these supervisor with SUP-2x wahat is required exactly.
Hello Gents,i have SDA fabric with integrated WLC and i create SSID gor Guest but need to make rate lmit for Guest SSID also i need to make guest connected for 4 hours and after that get dis-connected and re connect again as new guest.
i have DNAC cluster . i have one server has hard disk failure. so after replace hard disk , shall i remove server from cluster and re-image it again. if yes , how to remove server from cluster and add it again
Hello balaji,i need to change as ip for lo0 is included in another branch as subnet .i don't use template by DNAC.yes it's live and i will request downtime .can you explain more about steps as i checked edge switches and i found they use ip add for l...
Hello Marce.thanks for your reply.both ISE nodes pxgrid is enabled.primary node is connected and up but other has issue. both ISE nodes has same versionDNAC version is 2.3.5.5
