Guest SSID BW limit in SDA Fabric

[ahmed ramadan mohamed]

Hello Gents,

i have SDA fabric with integrated WLC and i create SSID gor Guest but need to make rate lmit for Guest SSID also i need to make guest connected for 4 hours and after that get dis-connected and re connect again as new guest.

[Torbjørn]

You will need to use "Advanced SSID Configuration" model config to configure rate limiting. See docs for this here: https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-3-3/user_guide/b_cisco_dna_center_ug_2_3_3/b_cisco_dna_center_ug_2_3_3_chapter_01001.html#task_zbt_pvm_h4b 

For implementing guest time restriction you need to set "Maximum access time" under your ISE guest portal configuration.

[ahmed ramadan mohamed]

I Tried this but it's not supported for WLC 9800

[Torbjørn]

Which part is not supported? Are you getting a specific error?

[ahmed ramadan mohamed]

[Torbjørn]

Huh, you learn something new every day!

I found this technote describing how you can achieve per SSID rate-limiting using AAA/ISE: https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/215441-configure-qos-rate-limiting-on-catalyst.html. I haven't done this myself before, but I am happy to lab it up if you run into issues