Hi All, I have vmanage version 20.8 in my eveng lab and it was working fine until yesterday. Today when i started the lab, the vmanage GUI is not available. Its says the server is busy. I checked the resource/cpu etc and i have 32GB RAM and 8 vCPU. I...
Hi All, I tried to login to vmanage, its saying the account is locked out due to failed attempts. This is the lab in Eve-NG. Do you know how long does it take to unlock? Also, not sure where this login attempts coming from..
Hi All,I have asa firewall and I use anyconnect vpn. My ISP IP changes frequently so am looking to configure ddns so that I can simple enter fqdn name instead of IP while using anyconnect. How do I configure this please?
Hi All, I configured anyconnect vpn in ASA and its working ok. I enabled ASDM access in inside interface (10.10.50.254). After connecting to VPN, i tried to ping and connect to ASDM on 10.10.50.254 but its not working and i get "routing failed to loc...
Hi All, I configured anyconnect vpn. I can connect to it but cant ping internal network. Not sure what am missing here, any help is much appreciated. * Configured no-nat rule (bi-directional) between the inside (192.168.40.0/24) and outside (10.10.50...
Yes, the below guide says i can use ddns or http as the update method. In ASA i can see the only available method is ddns and not http. I done ddns method but its not working as shown in the output above. https://www.noip.com/support/knowledgebase/u...
Am using 9.12(4)40. Below is the config. I cant see http option under update method. Do i need to upgrade the firmware? I created account and domain in noip.com Home-FW# sh ddns update interfaceDynamic DNS Update on Outside:Update Method Name Update ...
Unfortunately its still the same. I cant ping, browse or connect via ASDM. Does the NAT rule looks ok? When i ping 10.10.50.254 from laptop, I cant even see the hits in Outside incoming access rule. # sh run | i httpaaa authentication http console LO...
Thank you, I have made the changes but i still cant able to ping or use ASDM on inside interface after connecting to anyconnect vpn. It still says "routing failed to locate next hop for TCP". Not sure what am missing here. Home-FW# sh run | i manage...