Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.. I am trying to import my configuration from router (7206) running IOS IPS. However iam getting the following error (Screenshot attached). Anyone has any idea where iam going wrong. I beleive it is some configuration mistake in the router.th...
Hi I have two 2 MB Link terminated to my router of which one is serial and other is an Ethernet termination. How can i configure the Ethernet link to act as a backup to serial(no load balancing required). Presently i have added both the interface in ...
Hi, I have a router with 2 WAN connections, One 2 MB E1 terminated to serial link and another wireless link terminated to Ethernet. Is it possible to load balance between the two. If so how?thanks in advanceRajesh
Hi, Iam using LMS 2.6. I had taken backup in a new HDD in the server.The Backup was successful. After that I scheduled the backup and the backup failed on the scheduled date with an error stating no write access to the drive. The same error came whe...
Hi.. make the following checks1. check if remote router is powered on or if there is link failure 2. Check encapsulation at both ends.3. check clock-ratergdsrajesh
hi david, The same issue is shown for all. I tried with putty, hyper terminal and windows CMD mode. naveen, I have tried tried restarting the router, reconfiguring, changing the flash card ( as iam not able to reload the IOS since it gets stuck in...
