Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a websense server on the network and I wanted to know if anyone knows the commande to allow a specific IP to bypass the server?This is what I have on my PIX now.url-server (inside) vendor websense host 10.x.x.x timeout 5 protocol TCPThanks in ...
Thanks in advance!!Does any one know what is an alternative command to add an access list for NTP access from segment A to Segment B.? I have tried to use the NTP and port number and the IOS will not take the command."Access-list 100 permit udp x.x...
All,Thanks in advance! I have an issue with one of my BDR routers and the cisco 2611 has lost its image and will not boot and I am unabel to access the router via console. When I connect via console cable I get nothing but "*******^%%$$#$%^" jibber...
All,I have a Cat4006 with a router card and I am unable to telnet nor ssh to either of the cards. On the Mod1 (Swtich Card) I am able to console and not ssh or telnet. I recieve a connection to host lost. On the Mod2 (RtR Card) I am able to telnet...
All,I just wanted to get some input. I just recently started here at a site and I am unable to access the the user switch via ssh and telnet. Due to limited access to the switches to be able to create a raidus or local login what possibly can be th...
Good luck!! Froggy has an excellent example.... Also, all ip routing should point to your gateway.sh ip route>ip route 192.168.1.1 x.x.x.x ((gateway ip))
Thanks for the heads up! A minute after I wrote this I changed the speed setting under TTERM and that fixed it. lol. That last Engr made this change possibly be accident.Thanks again!
Thanks for the information. Do you happen to where I can find the command on CATOS? I am unable to access telnet on mod1 (Switch card). The connection is established then drops once it tries to intiate the connection."Connection to host lost."Pres...
