Hi all, I have to update the config on my Cisco ISE nodes to point their SNMP trap messages to PRTG. Is it possible to send a test SNMP trap to PRTG to confirm that it's working instead of actually triggering an event?
Hi all and apologies in advance if this topic has been covered here already (at least I couldnt find it) but I am working on the Cisco SD-WAN 20.12 and wanted to see if its possible to create my own SD-WAN lab from scratch? Ie - spinning up fresh vMa...
Hi Marcelo and thanks for replying. I went into Context Visibility > Network Devices but I have no devices listed and it says "No data found". But within Administration > Network Devices all my devices are listed.
Just in case anyone is facing this issue today in EVE-NG, the method that worked for me was:1) Firstly change the Console method of the ASAv to "vnc"2) Boot up the node3) Let it load until you see the message "Lina to use serial port /dev/ttyS0 for c...
I had this exact same issue but in my case I had all my nodes powered on from a saved topology, all devices had default config. What enabled me to successfully install my vManage node was to power off all nodes and start from the beginning with the v...
I managed to get my External Connector working! Just in case anyone is in the same situation as me I found that I had connectivity between the CSR1000V router (within CML) and my computer after they had been on for just over 5 hours. Very weird... I ...
