Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had a working IPSec connection with another location. On our end, we replaced an old Pix 515 with a new ASA 5520 and since then, the tunnel will not come up with the following in the log:IP = x.x.75.65, Information Exchange processing failedIP = ...
I'm trying to set up an 802.1 q trunk between my layer 3 switch and ASA5520. I understand I need to create a subinterface to accomplish this and have done so. However, the subinterface does not respond to pings, and when I attempt to run the packet...
Hi, all.I'm running into what seems a basic ip routing config problem with a Catalyst 3750 (IP Base) switch. Hoping someone can point out the error of my ways.I have several VLANS configured on the switch with IP routing enabled, and the switch is c...
debug crypto isakmp returns:Apr 18 18:03:00 [IKEv1]: IP = x.x.75.65, Information Exchange processing failedSo yes, this seems to be phase one where the issue is. But it looks like all the phase one parameters match?show crypto isakmp sa returns: A...
Thanks for the reply.A bit more info - the ASA is part of an active/active pair, and from what I understand, the VLAN can only be set at the system level. I have done this for int gigabitethernet0/0.2 in the system config (VLAN2), but for some reaso...
Rick and Kamil - You're both right about this one. I was so focused on the switch config and the fact it could ping the firewall, I neglected to realize firewall doesn't actually know about the .100 subnet I added a network object and the proper rout...
