Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I upgraded 2110 with ASA image using this procedure (from 9.8.2 to 9.9.1.4):Cisco ASA Upgrade Guide - Upgrade the ASA Appliance or ASAv [Cisco ASA 5500-X Series Firewalls] - CiscoDuring upgrade this were the logs (some logs are ommited):INFO: V...
Hello!We have ISE 2.3. Every few hours we get following alarms: Configured nameserver is down Server=mfcu-ise1Configured nameserver is down Server=mfcu-ise2mfcu-ise1 and mfcu-ise2 are names of the ISE servers itself. mfcu-ise1 is primary, mfcu-ise2 i...
Hi!I'm trying to migrate ACS configuration using migration tool. ACS is 5.5, ISE is 2.3. All configuration is migrated ok, except internal users. In migration.log I found these lines:2017-11-14 15:43:13,742 [INFO] Thread-89 Start Exporting Users 2017...
Hello,I noticed something in RME 4.0.3. In RME > Tools > Syslog > Automated Actions there is system-defined automated action which is called Config Fetch. It collects configuration when it receives one of defined syslog mesasages. For PIX it tracks 1...
Hello!I noticed that PIX can't use RIPv2 routing updates which have tagged routes (tag different than zero). For such routing updates I got this error message:107002: RIP pkt failed from 10.1.20.1: version=2 on interface outsideIs this the feature or...
Hi! Thank you for your answer. Re-image helped. I used 9.9.2 for re-image and after that device is up and it is running ok.I think that something is wrong with version 9.9.1.4. I upgraded second firewall directly to 9.9.2 without any problems.Regards...
Hi!Thank you. All names are correct.I was thinking to open a case, but at the end I upgraded ACS form 5.5 to 5.8 and users were exported from ACS JMaja
