Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,Our company recently acquired several ASR920-4SZ and ASR920-24SZ platforms that were operating with the advancedmetroipaccess license.Prior to upgrading the devices, the output of show version indicated:License Type: PermanentAfter performi...
Greetings,I ran into an interesting issue on the N540-24Z8Q2C-M devices. I am currently validating an L2VPN service, and one of my standard tests is using ping mpls pseudowire to verify VC connectivity.In my network I have several platforms (ASR920, ...
Greetings I got an issue with the NCS-540 N540-24Z8Q2C-M. After a power cycle the router get stuck in sysadmin console and not the XR console. I try to Ctrl + o multiple times to change mode but it didn't work. Here the boot process:#### Waiting for ...
Greetings I got a N540-24Z8Q2C-M and I have an active alarm for a voltage sensor with value 0 0/RP0-CPU-ADM1166_VOUT_CH7.Can this issue could cause more problems in the future? Or this could be an indication of hardware problems and I need to replace...
Hi @Cristian Matei thanks for the information. I try it but still fails in ASR920#ping mpls pseudowire 10.1.1.211 1003555 reply mode router-alertSending 5, 72-byte MPLS Echos to 10.1.1.211,timeout is 2 seconds, send interval is 0 msec:Codes: '!' - su...
Hi @Cristian Matei Here output of NCS540sh l2vpn xconnect pw-id 1003555 detailThu Jan 29 12:01:27.818 ASTGroup my-group, XC 3555, state is up; Interworking noneAC: TenGigE0/0/0/0.3555, state is upType VLAN; Num Ranges: 1Rewrite Tags: []VLAN ranges: [...
Hi @Cristian Matei do you have 24.4.2 in production? I have 7.11.2 with all SMU installed and I have all kinds of issue. Random reboot, the disk sometimes goes read only mode and need to reboot, the 25/10G port stop working in 10G mode, sometimes I c...
@Mark Elsen Thanks for the information.One question if you can help me. I see in another post that have the same issue but the person did have access to the sysadmin console and see the default-sdr in state shutoffLocation: 0/RP0Id ...
