Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,Please see the attached diagram, I am tasked with changing the Interface loopback 0 IP which is currently used for bgp router id and ibgp neighborship with the interface loopback 1.Below is my plan, let me know if I am missing anything...
Hello Everyone,Please see the attached diagram, I am tasked with changing the Interface loopback 0 IP which is currently used for bgp router id and ibgp neighborship with the interface loopback 1.Below is my plan, let me know if I am missing anything...
Please refer to the attached diagram.R1,7K-A ,7K-B are EIGRP neighbors with each other, There are no issues with the neighborship and no filter's applied.7K-A & 7K-B can learn route 172.16.0.0/16 from R1 but the same route is not exchanged between 7K...
Sorry, I forgot to mention that I do not see the route in the eigrp topology table.As per my understanding even if the route do not pass the feasibility condition, The route should be in the topology table of the eigrp.
As per TACThe best command to retrieve debounce information specifically is `attach mod x` followed by `show system internal port-client link-event`. It’s module-wide instead of interface specific, there is no direct equivalent to the ethpc commands ...
